router bit
-
Franmar: Thirty Years of Safer Soy-based Cleaning Products
Safer cleaners and finish strippers from a renewable source.
-
Can I Sharpen My Carbide Cutting Tools with a Diamond Hone?
Is sharpening carbide a DIY job?
-
Infinity Mega Dado & Planer Bit
Two-inch cutting width should make quick work of tenons and flattening tasks.
-
Router Bit Bumpers Eliminate Guesswork
Router bits should not bottom out in the arbor shaft of a router, because it can compromise tightening them properly in the collet
-
Freeing Stuck Router Bits
Every so often, router bits get stuck in their collets – especially with older collets that aren’t selfreleasing.
-
Router Bits Moving During Cuts?
When I’m using my router table the bit sometimes works its way up. I was wondering if I am trying to take too much off or could it be my router?
