Q & A

Sanding Grit on Plywood Grade

What grit is “A” grade ply sanded to from the factory?

by Reader Submitted • Sep 22, 2009 • Q & A
Recommended for Ripping

I have a fair amount of aged oak timbers that are about 2×12 rough and full cut. They would make great tabletops, good stuff. What would you recommend to rip them?

by Reader Submitted • Sep 22, 2009 • Q & A
Bowing Cabinet Doors

I have made some kitchen cabinets, and the doors are made of poplar frame with paneling in the middle. They are so bowed it is heartbreaking. How can I remedy this?

by Reader Submitted • Sep 22, 2009 • Q & A
Templates for Letters

Where can I find templates for the letters used in the toy box project?

by Reader Submitted • Sep 8, 2009 • Q & A
How to Harvest a Burl

What is the best way to harvest the burl for future turning?

by Reader Submitted • Sep 8, 2009 • Q & A
Finish Inside of Cedar Chest?

How should I finish the inside of a cedar chest so as not to lose the aroma?

by Reader Submitted • Sep 8, 2009 • Q & A
Polishing Mirror Glass Surface

It was interesting learning about resilvering a mirror, however I need information on polishing the mirror glass surface which I inadvertently scratched.

by Reader Submitted • Aug 25, 2009 • Q & A
Info on Fine-Tuning Planers and Jointers

Where can I get information on fine-tuning planers and jointers?

by Reader Submitted • Aug 25, 2009 • Q & A
Guidelines for Finishing Honeylocust

Do you have any guidelines for finishing honeylocust?

by Reader Submitted • Aug 25, 2009 • Q & A
Finishing Cedar for Indoors

There’s lots of information on finishing outdoor cedar furniture, but how do I finish an indoor cedar kitchen table?

by Reader Submitted • Aug 25, 2009 • Q & A