Q & A

Finding Squirrel Cage Blower Specs?

How can I determine the CFM of the blower, and will the CFM affect the size of the filter I should use?

by Reader Submitted • Apr 19, 2011 • Q & A
Anchoring Upper Case of Tallboy?

I would like to know how to stabilize the tallboy once it is finished so it doesn’t tip once all the drawers are open while they are full.

by Reader Submitted • Apr 5, 2011 • Q & A
What’s the Best Finish for Butcher Block?

Our experts share the best woodworking finish to apply to surfaces that will be in direct contact with food.

by Journal Staff • Apr 5, 2011 • Q & A
Patching Dog-damaged Veneer?

How do I square up the damaged wood, and can I just glue in a matching veneer section, sand the joints smooth and refinish?

by Reader Submitted • Mar 22, 2011 • Q & A
Is a Pilot Light Safe in My Shop?

I understand that airborne wood dust is flammable and may be an issue with the water heater pilot light. Will this be a dangerous mix?

by Reader Submitted • Mar 22, 2011 • Q & A
De-gunking Diamond Stones?

I’m wondering if there is a way to clean the stone to like-new condition?

by Reader Submitted • Mar 22, 2011 • Q & A
Removing Rust Rings from Cast Iron?

Could someone tell me how to clean rust and rings left by someone leaving glass on my table saw?

by Reader Submitted • Mar 8, 2011 • Q & A
How Thick Should a Butcher Block Countertop Be?

On a top this large, is it appropriate to build it in 12′ – 13′ sections that then are glued together for the final phase?

by Reader Submitted • Mar 8, 2011 • Q & A
Anchoring a New Railing?

I want to replace it with a walnut railing, but I’m not sure how best to anchor it so it will provide proper support and safety.

by Reader Submitted • Mar 8, 2011 • Q & A
Easy-to-reach Router Switches?

I was very anxious to start some of the router practices and projects that I have been collecting, but cannot find a router that I can use safely.

by Reader Submitted • Feb 22, 2011 • Q & A