Q & A

• 

  Sharpening a Carbide Tip

  How do you sharpen a carbide tip?

  by Reader Submitted • Aug 30, 2005 • Q & A
• 

  Ways to Cut a Hinge Mortise

  Is there a better way to cut hinge mortises than with a chisel and mallet?

  by Reader Submitted • Aug 30, 2005 • Q & A
• 

  Wherefore Radial Arm Saws?

  Why is there almost no mention of the use of a radial arm saw in woodworking magazines, proposed shop layouts and so forth?

  by Reader Submitted • Aug 30, 2005 • Q & A
• 

  Filling Incorrectly Drilled Hole

  What’s the best way to fill an incorrectly drilled hole that will have to be re-drilled later?

  by Reader Submitted • Aug 16, 2005 • Q & A
• 

  Gluing Up Corian

  I have some Corian scraps that I wish to glue together and turn on my lathe. What type of glue should I use?

  by Reader Submitted • Aug 16, 2005 • Q & A
• 

  Radius Edge Making

  I purchased a large, 2″ radius roundover bit, but it’s so big it doesn’t fit the hole in my router base. How would you go about making a large radius edge on a table?

  by Reader Submitted • Aug 16, 2005 • Q & A
• 

  White Stain Removal

  We discovered a white stain left from the paper plate. Is there anything I can do to restore this or remove the stain?

  by Matt Hocking • Aug 16, 2005 • Q & A
• 

  Fairing a Template

  The experts give concise explanations of what it means to “fair” a template.

  by Reader Submitted • Aug 2, 2005 • Q & A
• 

  Router Speed Settings

  I was wondering if there is a rule of thumb on speed settings for different applications, wood types or type of bit when using a router?

  by Reader Submitted • Aug 2, 2005 • Q & A
• 

  Why a (Flat) Pencil Sharpener?

  Could someone give me a logical reason for a pencil sharpener for a flat lead pencil?

  by Reader Submitted • Aug 2, 2005 • Q & A